From the Jobs section of your Roofr dashboard, click +New

Select Job and enter the address, click Continue

From the created Job Card, click the + button and select Create DIY Report

Click the Upload button, and select your blueprint file

Select a horizontal line on your Blueprint to use for scale

Click Draw a line

Draw the scale line precisely over the drawing in the DIY drawing screen and enter the length in feet and inches, click OK

Review the elevations on your blueprint to draw your layers

Start by drawing the lines on the layers closest to the ground

Next, draw the perimeter of the structure and all lines of the roof

Begin at the highest layer by clicking the corresponding letter in the Layers tool bar

Click the Edges tab to view the Edges tool bar

Click the label of the edge type in the tool bar and then click on the corresponding lines to label that line

Move through all layers and ensure that each line is labeled correctly

Click the Facets tab to view the Facets tool bar

Click the layer you wish to start labelling on, typically the top layer

Click the numbered pitch in the Facets tool bar, and then into the selected facet to label it

Move through each layer to apply pitch

Your measurement will be listed as ‘In progress’ until you mark it as done

The drawing will auto-save every few seconds, but you can click the save button to manually save at any time

Click Mark as Done to finalize your report

Download a PDF or CSV of the report by clicking the arrow icon on the top right of the view screen